|
4 EASY STEPS TO OPERATE YOUR AC420 ANGELCARE® SOUND MONITOR
 1. NURSERY UNIT (TRANSMITTER)
• Insert 4 AAA regular batteries (not included) into nursery unit (for battery backup in case of power failure).
• Connect AC adapter to nursery unit and plug adapter into anelectrical outlet in the baby’s room.
• After both units are properly installed (step1 and 2), turn them ON and then adjust microphone sensitivity level (if
necessary).
 2. PARENTS UNIT (RECEIVER)
• Insert 4 AAA NIMH rechargeable batteries (included) into parents unit.
• Connect AC adapter to parents unit charger and plug adapter into an electrical outlet. Let charge for 15 continuous hours before using the monitor for the first time.
• After both units are properly installed (step1 and 2), turn them ON and then adjust the volume control to the desired level.
3. HOW TO USE YOUR MONITOR
• To be warned if your units are “out of range”, switch the In Range Notification ON (optional).
• If reception is not clear, switch to another channel. (see instructions for changing channel in the “ICON” section).
• To avoid feedback (whistling sound), keep both units at least 3 meters apart (10 feet).
4. USING THE BATTERY MODE
• The monitor will revert to battery mode during a power failure only if batteries are inserted in both units.
• When the nursery unit’s green light flashes, its batteries need to be replaced. On the parents unit screen, the clear
battery icon flashes and the nursery unit icon appears. A beep sound is also heard.
• Parents unit should be recharged when icon is clear (does not flash) and a beep sound is heard. Note: Do not use
Alkaline batteries in the parents unit.
|
